Accessories
Pair of Clamps
(reference 166)
V
Arm rest
(reference 2536)
H
VS
B
VS
Caution
Clamps are necessary to install these accessories.
(réf. : 166)
Installing the Clamps
Take the stopper (B) out of the square tube if
necessary. Loosen the nuts (V), and put the pair of
clamps ref.166 (E) into position in the square tubes.
Tighten the nuts.
The clamps accept accessories with a diameter of 16
mm.
E
Adjusting the arm rest
The standard arm rests can be adjusted in height (H)
and can be positioned in all directions due to the ball
and socket joint underneath the armrest. To adjust
the armrests, loosen the screws (VS) and position as
desired.
Caution
Re-tighten the screws before
use.