Manufacturer; Manufacturer Address; Warranty And Limitation Of Liability - Nidec SPDM CONTROL BOX User Manual

SPDM CONTROL BOX

MANUFACTURER

SILCOPAC D and SPDM CONTROL BOX are built at the Nidec ASI S.p.A. plant in Montebello (VI) - Italy

MANUFACTURER ADDRESS

For any type of information regarding use, maintenance, installation, customer assistance at the customer's premises, ordering spare parts,
etc. contact the closest Nidec customer assistance centre.
The manufacturer is always available to satisfy the purchaser/customer's requests for any type of information or clarification on use,
maintenance, installation, etc.
It is important for the purchaser/customer to ask questions referencing this manual, always indicating the data found on the SPDM CONTROL
BOX identification plate.

WARRANTY AND LIMITATION OF LIABILITY

Refer to the order acceptance for the warranty period and conditions.
The manufacturer is not liable for damage caused during transport, reception, installation or commissioning.
The manufacturer is not liable for damages or consequences due to inappropriate, negligent or improper drive installation, incorrect drive
operating parameter setting, installation in a dusty location, with corrosive substances, with excessive vibrations or operating temperatures
exceeding the nominal data.
The customer must always purchase original spare parts, under penalty of voiding the warranty.
The manufacturer declines all liability due to incorrectly or improperly using the system, using non-recommended spare parts and tampering
with the circuits and system components.
The manufacturer declines all liability for any damage caused by the SPDM CONTROL BOX to people, animals or property in the following
cases:

Incorrect use or for different purposes to those for which it was built

Incorrect incorporation/installation in machine, system or equipment for which it was intended.

Failure to comply with the installation/incorporation rules stated in this Manual

Use by unqualified or unauthorised personnel

Defects in the electrical, hydraulic, pneumatic and water supplies (if any)

Failure to comply with the technical specifications concerning the power supplies listed in chapter 2 of this Manual

Missing or insufficient periodic maintenance

Modifications or interventions on the equipment not agreed upon with or authorised by the Manufacturer

Using non-original spare parts or, in any case, different spare parts to those specified

Total or partial non-compliance with the instructions contained in this Manual.
Following the safety rules listed hereinafter is the responsibility of whoever plans and manages the tasks expected for the SPDM CONTROL
BOX, who must make sure that authorised personnel:

are qualified to perform the requested activities

know and carefully follow the rules in this Manual

know and apply all general and specific safety rules applicable to the SPDM CONTROL BOX.
Failure to follow the safety rules may cause injuries to personnel and damage the SPDM CONTROL BOX.
NIDEC ASI S.P.A. – SPDM CONTROL BOX USER MANUAL
IMSPDCB2EN
INTRODUCTION
1