Nidec SPDM CONTROL BOX User Manual page 41

SPDM CONTROL BOX
NOTE:
3.1.1.9 P21, SELECTION OF THE SOURCE FOR ADCINA4
The P21 jumper selects the source of the analog input ADCINA1 of DSP. The table below illustrates this configuration.
NOTE:
3.1.1.10 P23, SELECTION OF THE SIGNAL FOR PIN 32 OF CONNECTOR J14
The jumper P23 must be configured depending on the type of signal present on pin 32 of the J14 connector (encoder expansion). The table below
illustrates the setup.
NOTE:
3.1.1.11 P24, SELECTION OF THE SIGNAL FOR PIN 4 OF CONNECTOR J11
The jumper P24 must be configured depending on the type of signal present on pin 4 of the J11 connector. The table below illustrates the setup.
Config. P24
1-2
2-3
3.1.1.12 P25, SELECTION OF THE S1GNAL FOR PIN 5 OF CONNECTOR J11
The jumper P25 must be configured depending on the type of signal present on pin 5 of the J11 connector. The table below illustrates the setup.
Config. P25
1-2
2-3
3.1.1.13 P26 AND P27, STATE JUMPERS
The jumpers P25 and P26 can configure four different combinations that the software can read for particular application requirements.
NIDEC ASI S.P.A. – SPDM CONTROL BOX USER MANUAL
IMSPDCB2EN
In the SPDM CONTROL BOX, P20 must be set on default position 1-2.
Config. P21
1-2
2-3
Table 3-8: Configuration of jumper P21.
In the SPDM CONTROL BOX, P21 must be set on default position 1-2.
Config. P23
1-2
2-3
Tabella 3-9: Configuration of jumper P23.
In the SPDM CONTROL BOX, P21 must be set on default position 1-2.
Signal on J11 pin 4
TAST_TXRX+
KPCLK
Table 3-10: Configuration of jumper P24.
Signal
TAST_TXRX-
KPSP
Table 3-11: Configuration jumper P25.
Source for ADCINA4 input
Input from pins 9/10 of connector J26
Sum of inputs from pins 11/12+13/14 of connector J26
Signal
RES1 (Analog from resolver expansion)
GPIOF11 (digital from Analog expansion GEOSA)
3 – SYSTEM2 BOARD
35