Primary Wiring; Secondary Wiring; Control Wiring - Q-tran QTM-DRIVE Manual

INSTALLATION
Connecting and Configuring the LINEARdrive 100/S
DMX in +
-
DMX in
DMX in shield
LedSync out +
LedSync out -
LedSync out
shield
Ext in +
-
Ext in
-
DA
+
-
DA
+
~
~

Primary Wiring

Green = Ground
-
DA
+
-
DA
+
Black = Hot
~
White = Neutral
~

Secondary Wiring

-
DA
+
-
DA
+
Red = Red
Green = Green
Blue = Blue
~
White = White
~
Black = +24V
- +
M
WARNING:
Risk of electrical shock. May result in serious injury or death. Disconnect power before servicing or installing.
CAUTION:
The device may only be connected and installed by a qualified electrician. All applicable regulations, legislation and building codes must be observed.
Incorrect installation of the device can cause irreparable damage to the device and the connected LEDs.
© 2020 Q-Tran Inc. All rights reserved | 155 Hill St. Milford, CT 06460 | 203-367-8777 | sales@q-tran.com | www.q-tran.com
LED POWER SUPPLY - QTM-DRIVE
R G B W
Common anode
R R R R
12V / 24V DIP switch
DALI
120-277
L
VAC
N
Commonly Asked Questions
1) How can I verify my installation?
• Apply AC input, verify display turns on : This confirms AC input wiring
• Run "Visual Test Run" : This verifies wiring of LEDs. Make sure LEDs turning on go in same order as the Test Run
2) I don't have a controller yet, how can I keep my lights on?
• Change the Mode to "COLOR" : This allows to manually set a specific color to be on
• Adjust the Hue or WHITE to achieve the desired color : This sets that specific color
3) My LEDs aren't coming out the right color. They look like white has been added in
• Verify the Network Resolution "NETW RES" : Default is 8 BT
• Check your DMX Programming. Stick controllers come with RGB programs by default. This will cause RGBW
LEDs to show Pink vs. Red
120-277VAC
50-60Hz
1 2
R G B W +24V
LED
Red = Red
Green = Green
Blue = Blue
R G B W+24
White = White
Black = +24V
PRIMARY
SECONDARY
DMX Shield
DMX -
DMX +

Control Wiring

DMX Connections
DMX connections
DMX in +
DMX in -
M
DMX in shield
-
DA
+
-
DA
+
~
~
NOTE: The unit will be factory wired based on the way the unit is ordered.
Only the one applicable control will be prepared.
: DMX shielding wire must be grounded to Earth ground external to power supply.
A B
DMX IN DMX OUT
To next
power supply
A B
R G B W+24
Red DMX +
Blue DMX -
GND
Green
DALI Connections
DALI connections
_
+
-
DA
+
-
DA
+
~
~
Specification subject to change. Rev-09-29-20
GND
HOT
NEU
_
+
_
+