Primary Wiring; Secondary Wiring - Q-tran QTM-eLED+DALI-DT8-AN Installation Manual

INSTALLATION
Connecting and Configuring the DALI-DT8 Decoder
24VDC IN
*Internal to QTM unit
- +
D1+ D1+
D1- D1-
D2+ D2+
D2- D2-

Primary Wiring

D1+
D1-
GND
D2+
D2-
HOT
NEU
WARNING: Risk of electrical shock. May result in serious injury or death. Disconnect power before servicing or installing.
CAUTION: The device may only be connected and installed by a qualified electrician. All applicable regulations, legislation and building codes
must be observed. Incorrect installation of the device can cause irreparable damage to the device and the connected LEDs.
© 2021 Q-Tran Inc. All rights reserved | 155 Hill St. Milford, CT 06460 | 203-367-8777 | sales@q-tran.com | www.q-tran.com
LED POWER SUPPLY - QTM-eLED+DALI-DT8-AN
V-
V-
V+
V+
+
CW-
WW-
CW-
WW-

Secondary Wiring

3-Wire default
V-
V-
V+
V+
+
CW-
WW-
CW-
WW-
3-Wire
HOT NEU
24VDC IN LED groups
DALI Signal
in/out
DALI
+24V W C
IN
NOTE:
For customization or pre-programming
Warm
contact a local sales rep.
DALI commissioning to be performed by a
Cool
third party at time of installation.
+24V
Specification subject to change. Rev-06-13-23