Primary Wiring; Control Wiring - Q-tran QOM-eLED+IA Quick Start Manual

INSTALLATION
Connecting And Configuring the DMX-to-SPI decoder
DMX Output
+24V

Primary Wiring

Control Wiring

DMX connections
DMX -
DMX
SPI DECODER
DMX +
GND
NOTE: DMX Shield must be grounded to Earth Ground at a single point
external to power supply
WARNING:
CAUTION:
© 2020 Q-Tran Inc. All rights reserved | 155 Hill St. Milford, CT 06460 | 203-367-8777 | sales@q-tran.com | www.q-tran.com
DMX Input
GND GND
DMX + DMX +
+24V
DMX - DMX -
GND
GND
HOT
HOT
NEU
NEU
DMX -
DMX +
Shield
Risk of electrical shock. May result in serious injury or death. Disconnect power before servicing or installing.
The device may only be connected and installed by a qualified electrician. All applicable regulations, legislation and building codes must be observed.
Incorrect installation of the device can cause irreparable damage to the device and the connected LEDs.
LED POWER SUPPLY - QOM-eLED+IA
Red
Blue
Black
Wiring
DMX
to SPI DECODER
+24V
LED DRIVER 2
(120 - 277V)
+ -
DATA
A
LED
B A
+ - + -
DATA DATA
DMX OUT DMX IN
SECONDARY
PRIMARY
Red
To next
power supply
Blue
+ Green
Data
-
Specification subject to change. Rev-09-29-20
LED DRIVER 2
(120 - 277V)
C
DMX
LED DRIVER
(120 - 277V)
DMX +
DMX -
GND
GND
HOT
NEU
Red +
Blue DATA
-
Black