Table of Contents
Advertisement
INSTALLATION
Connecting and Configuring the LINEARdrive 100D/180D
DMX in shield
DMX in -
Ext in -
DMX in +
Ext in +
Primary Wiring
GND
HOT
NEU
Secondary Wiring
TC
LED supply +
Group
1
Group
2
e 180D
Group
3
Group
4
Black Wire = +24V
Red Wire = Red LED
Green Wire = Green LED
Blue Wire = Blue LED
White Wire = White LED
-
M
WARNING:
Risk of electrical shock. May result in serious injury or death. Disconnect power before servicing or installing.
CAUTION:
The device may only be connected and installed by a qualified electrician. All applicable regulations, legislation and building codes must be observed.
© 2021 Q-Tran Inc. All rights reserved | 155 Hill St. Milford, CT 06460 | 203-367-8777 | sales@q-tran.com | www.q-tran.com
To DMX Controller
LedSync shield
LedSync thyu -
Ext in -
LedSync thyu +
Ext in +
Commonly Asked Questions
1) How can I verify my installation?
• Apply AC input, verify display turns on : This confirms AC input wiring
• Run "Visual Test Run" : This verifies wiring of LEDs. Make sure LEDs turning on go in same order as the Test Run
2) I don't have a controller yet, how can I keep my lights on?
GND
• Change the Mode to "COLOR" : This allows to manually set a specific color to be on
HOT
• Adjust the Hue or WHITE to achieve the desired color : This sets that specific color
NEU
3) My LEDs aren't coming out the right color. They look like white has been added in
• Verify the Network Resolution "NETW RES" : Default is 8 BT
• Check your DMX Programming. Stick controllers come with RGB programs by default. This will cause RGBW
LEDs to show Pink vs. Red
+
Incorrect installation of the device can cause irreparable damage to the device and the connected LEDs.
●
DMX Shield must be grounded to Earth Ground at a single point external to power supply
LED POWER SUPPLY - QOM-eLED+DMX
R G B W+24
iQ-LED
Blue Wire = Blue LED
Red Wire
= Red LED
Green Wire = Green LED
White Wire = White LED
Black Wire = +24V
DMX Shield
DMX -
DMX +
SECONDARY
PRIMARY
Control Wiring
DMX Connections
LedSync shield
LedSync thru -
LedSync thru +
DMX in shield
DMX in -
DMX in +
LED DRIVER 2
(120 - 277V)
A
B
C
DMX IN DMX OUT
DMX IN
DMX OUT
R G B W+24
DMX in shield
DMX in -
DMX in +
Specification subject to change. Rev-12-08-21
LED DRIVER
(120 - 277V)
GND
HOT
NEU
Advertisement
Table of Contents
