Q-tran QTM-DRIVE Manual page 2

QTM-DRIVE
Housing
• 18 gauge welded steel enclosure: 14.5"W x 8.00"H x 4.00"D
• Door: 15.5"W x 9.00"H
• Knockouts: 9
• Built-in support bracket incorporated to secure housing for surface mounting
Performance
• Power Supply
: Rated for surface mount or recessed use
: Fully rated to operate low voltage load at listed wattage (No derating required)
: Voltage regulation to 5% or less of rated output voltage
: Universal input range of 120-277 Vrms
• Low Voltage Lighting Systems
: CSA Class 3425-15 and Class 3425-95
: Short circuit protection (SCP)
: Overloadprotection (OLP)
: Live tested by the manufacture to ensure proper operation
: Manufacturer offers a minimum of 5 years warranty
• Terminal blocks is made of tin plated copper with a voltage rating of 300V and a current rating of 40A
•
DMX or DALI controllable
•
Can fit up to 2 drivers
•
Surface or recess mount capable
•
4x 12/24V controllable outputs per driver
•
Standby power: < 0.5W
•
Flicker free operation
•
Built-in surge rotection: 3kV (L to N), 4kV (L/N to GND)
•
Efficiency: 90% at full load, ≥ 87% above 50W output
•
Power factor: > 0.94
•
THD @ full load : <10%
© 2020 Q-Tran Inc. All rights reserved | 155 Hill St. Milford, CT 06460 | 203-367-8777 | sales@q-tran.com | www.q-tran.com
LED POWER SUPPLY 60W–200W
GND
HOT
NEU
14.5"
BOTTOM
9 Knockouts of 0.875" Hole for 1/2" fitting
16 additional side knockouts
NOTE:
•
DMX dimming down to 0%
•
3 years warranty
•
Class 2 output
•
CSA #239924
Low Voltage Lighting Systems
: CSA class 3425-15 and class 3425-95
: CSA standard C22.2 No. 250.0-08 - Luminaires
: ANSI/ UL standard2108 - Low voltage lighting systems
: CSA standard C22.2 No 250.13-14 - Light emitting diode (LED) equipment for lighting
applications
: ANSI/ UL standard8750 - Light emitting diode (LED) equipment for use in lighting
products
Specification subject to change. Rev-11-19-20