Troubleshooting; Specifications - SDMO Technic 7500 TE C Instruction And Maintenance Manual

9. Troubleshooting

Problems
Load connected to the generating set during start-up.
Oil level too low.
Engine red light indicator is turned on.
Oil filter (fig. B - No. 5) clogged.
Unsuitable fuel.
Engine not
Fuel level too low.
starting
Fuel tap (fig. A - No. 6) closed.
Fuel filter (fig. C - No. 3) clogged.
Air filter (fig. A - No. 7) clogged.
Faulty starter battery (fig. A - No. 13).
Defective spark plug (fig. E - No. 2).
Fuel supply blocked or leaking.
Oil level too low.
Engine red light indicator is turned on.
Engine stopped
Fuel level too low.
Blocked ventilation inlets.
Circuit breakers (fig. A - No. 11) not actuated.
Defective appliance supply cord.
No electric
current
Defective electrical sockets (fig. A - No. 12).
Defective alternator.
Device connected or faulty cord.
Triggering of
circuit breakers
Overload (see § Capacity of the generating set).
No working
Working hours counter fuse (fig. A - No. 15) faulty.
hours counter

10. Specifications

Model
Maximum output / Rated output
Acoustic pressure at 1 m
Engine type
Recommended fuel
Fuel tank capacity
Recommended oil
Oil sump capacity
Oil failure cut-out
Circuit breaker
Direct current
Alternating current
Socket type
Spark plug type
Battery
Dimensions l x w x h
Weight (without fuel)
● : standard ○ : option
AVR: The AVR system (Automatic Voltage Regulation) enables a more efficient stabilisation of the generating set voltage.
Probable causes
X: not possible
Possible solutions
Disconnect the load.
Check the oil level and top up if necessary
(see § Checking the oil level).
Check the oil level and top up if necessary
(see § Checking the oil level).
Replace the oil filter (see § Replacing the oil filter).
Change the fuel (see § Specifications).
Fill up with fuel (see § Filling with fuel).
Open the fuel tap.
Replace the fuel filter (see § Replacing the fuel filter).
Clean the air filter (see § Cleaning the air filter).
Recharge or replace the starter battery.
Check the spark plug (see § Checking the spark plug)
and replace if necessary.
Have it checked, repaired or replaced.*
Check the oil level and top up if necessary
(see § Checking the oil level).
Check the oil level and top up if necessary
(see § Checking the oil level).
Fill up with fuel (see § Filling with fuel).
Clean the generating set (see § Cleaning the
generating set).
Actuate the circuit breakers.
Change the cord.
Have it checked, repaired or replaced.*
Have it checked, repaired or replaced.*
Disconnect the device and the cord.
Remove the overload.
Have it checked, repaired or replaced.
* Operation(s) to be entrusted to one of our agents.
TECHNIC 7500 TE AVR C
6500 W / 5200 W
88 dB(A)
Kohler CH 15
Unleaded petrol
SAE 10W30
400V-7.5A
3 x 2P+T-230V-10/16A - 1 x 3P+N+T-400V-16A
CHAMPION : RC12YC
89.5 x 57 x 77 cm
TECHNIC 9000 TE C
7200 W / 5760 W
35 L
1.9 L
X
●
X
400V-8.3A
●
124 kg