Advertisement
Available languages
Available languages
mains: This connection must be state of the art according to the CEI standards in force.
EN
The power cable must be replaced by authorised technical personnel. Failure to comply with the provisions
listed above may compromise the safety of the appliance.
7.2
ELECTRICAL CONNECTION
First connect the power cable to the side of the boiler and then to a wall socket.
The main switch at the side must only be activated to switch the boiler on; otherwise, it is advisable to keep
it switched off.
8
INITIAL START-UP
8.1
GENERAL PRECAUTIONS
Remove all components that could burn from the brazier and glass (manual, various adhesive labels and
any polystyrene).
Check that the brazier is positioned correctly and rests properly on the base.
66
Hazard!
Electrical installation must be carried out by a qualified technician only.
Before performing connections or any operation on the electrical parts, always
disconnect the power supply and make sure it cannot be accidentally reconnected.
Please note that the boiler electrical power line must be fitted with a bipolar switch with
a contact gap greater than 3 mm, easy to access, in order to make any maintenance
operations quick and safe.
It is recommended to disconnect the boiler power cable when the boiler is not used.
Fig. 17 - Electrical connection of the stove
AQUOS - IDRON
Advertisement
Chapters
