Removal/Assembly Of Side Panels; Electric Connection - Cadel INDIGO EVO Installer Manual

• Remove the hinge, keeping the door in position (see Fig. 17).
• Lift the door and release it from the lower hinge (see Fig. 18).
• To assemble, proceed in reverse order.
Fig. 16 - Removing the screws
6.5

REMOVAL/ASSEMBLY OF SIDE PANELS

To disassemble the side panels, proceed as follows:
• Open the door.
• Undo the front screws (see Fig. 19).
• Open the side panel (see Fig. 20) and release the rear teeth (see Fig. 21).
• To assemble, proceed in reverse order.
Fig. 19 - Remove the screws
6.6

ELECTRIC CONNECTION

Warning: the appliance must be installed by an authorized technician!
• The electric connection occurs through a cable with plug put in an electric socket which is able to support charge and tension
specific of every model, as described in the technical datas table (see ).
• The plug must be easily accessible when the appliance is installed.
• Please further assure you that your network is endowed with an efficient earth connection: if it does not exist or if it is not
efficient, please endow you with one in compliance with the law.
• Connect the supply cable first on the back of the stove (see Fig. 22 and Fig. 23) and then at a wall electric socket.
14
VERA7 - INDIGO EVO 7 - VERA7 UP - CRISTAL 7UP
Fig. 17 - Remove the hinge
Fig. 20 - Rotate side panels
Fig. 18 - Remove the door
Fig. 21 - Remove side panels