Replacing The Air Compressor Serpentine Drive Belt - Vanair AIR N ARC RELIANT 300 Series Operations Manual & Parts List

®
AIR N ARC 300 SERIES ALL-IN-ONE POWER SYSTEM
B
KEY DESCRIPTION
A TENSIONER PLATE MOUNTING AND
ADJUSTMENT BOLTS
B IDLER
C TENSIONER PLATE
D TENSIONING HOLE
6.6.14.2 REPLACING THE AIR COMPRESSOR
SERPENTINE DRIVE BELT
To replace the air compressor serpentine belt consult
Figure 6-17 and the following procedure:
TOOLS NEEDED
Socket Wrench - Size 6 mm
Hex Head (for Tensioner
Plate Bolts)
Torque Wrench, 1/2" Drive
Ratchet, 1/2" with Extension
1. With the machine off and the truck off, open
and remove the access panel.
2. Position and route the new air compressor
serpentine belt as shown in Figure 6-17,
A
C D
Figure 6-16: Compressor Serpentine Belt Re-tensioning
REPLACEMENT
Serpentine Belt
No. DR27584
090034-OP_r0
®
E
G
KEY DESCRIPTION
E Loosen bolts to allow tensioner plate to pivot man-
ually to achieve new belt-tensioned position.
F Pivot plate by applying torque wrench to tension-
ing hole.
G Belt tension adjustment should be verified using a
tension tester.
PART(S)
SECTION 6: MAINTENANCE
F
PAGE - 95