Section 3: Specifications - Vanair AIR N ARC RELIANT 300 Series Operations Manual & Parts List

®
AIR N ARC 300 SERIES ALL-IN-ONE POWER SYSTEM
SPECIFICATIONS
TABLE 3A: WELDER, GENERATOR, AND ENGINE SPECIFICATIONS
SYSTEM INFORMATION
Rated Welder Output
Welding Leads
AC Generator
AC Generator 120V Power Rating
AC Generator 240V Power Rating
Battery Charger Capacity
Engine
Engine Oil Capacity
Fuel Consumption
Fuel Tank Capacity
Fuel Type
Operating Temperature Limits
I
For specification and requirements regarding the Kubota
II
Diesel Fuel Specification Type and Sulfur Content % (ppm) used must be compliant with all applicable emission regulations
for the area in which the engine is operated.
Engine manufacturer recommends a fuel sulfur content of less than 0.10% (1000 ppm). For fuels with a high sulfur content
0.50% (5000 ppm) to 1.0% (10000 ppm) a more frequent engine oil and oil filter change schedule is needed (approximately
half). DO NOT USE fuels with a sulfur content greater than 1.0% (10000 ppm). For additional information on fuel for this
engine, consult Section 5.8 (Extreme Conditions), and the Engine Operator's Manual.
Not recommended for bio-diesel blends over 5%.
TABLE 3B: SPECIFICATIONS — AIR COMPRESSOR
COMPRESSOR INFORMATION
Compressor Type
Air Compressor Capacity
Inlet Control
Air Filter
Oil Filter
Oil Capacity/Type
Air Tank Capacity
Tank Pressure Rating
Safety Relief Valve Setting
Operating Range (ambient)
Electrical System
Cooling System
Instrument Gauges
Adjustable Air Pressure Control
Settings
Air Service Outlets
®
SECTION 3:
300A High Frequency DC/CC, DC/CV; 100% Duty Cycle @ 280 Amps
25 or 50 Ft Optional (Refer to Section A.5 for Optional Parts Listing)
6800 Watts Continuous Duty
60 Hz 1 PH, 2-20 Amp Circuits
60 Hz 1 PH, 28 Amp
12V Charge, 12V Boost, 24V Boost
I
Diesel 25HP
Four (4) Quarts 10W30 (Refer to Engine Operator's Manual for Extreme Conditions)
1.25 GPH at Full Engine Speed/Load 9.6 Hour Runtime w/ 12 Gallon Tank
12 Gallons
II
Diesel Fuel
0°F to 110°F (-18°C to 43°C); Cold Weather Kit extends temperature range from 0°F to
-40°F (-18°C to -40°C)
®
25 HP Diesel Engine, refer to the Engine Operator's Manual.
Single Stage, Oil Injected Rotary Screw
40 CFM @ 175 PSI
Zero (0) No Load / 100% Load
Pleated Paper, Dry Type
Spin-on Type
New: 3.5 Quarts / Service: 2.5 Quarts [Vanguard™ Premium Synthetic Oil]
Four (4) Gallons
200 PSI
200 PSI
0° to 110°F (-18°C to 43°C); Cold Weather Kit needed for operating below 0°F(-18°C)
12 VDC
Air to Oil Heat Exchanger
Pressure and Hour Meter
Cut-in Pressure: 100 PSI / Cut-out Pressure: 125 PSI (Factory Preset); 150/175 PSI
(Maximum Cut-out)
Two (2) on Control Panel, One (1) on Machine
090012-OP_r0

SECTION 3: SPECIFICATIONS

SPECIFICATION
SPECIFICATION
PAGE - 33