Vanair AIR N ARC RELIANT 300 Series Operations Manual & Parts List page 56

SECTION 4: INSTALLATION
NOTE
For wet ups without a fuel tank where an
additional fuel pump is required, order
either of the following kits:
• Kit no. 032744 - Option for remote
fuel pump short run
• Kit no. 32745 - Option for remote
fuel pump long run
PAGE - 38
Figure 4-1: Mounting Location Space Requirements
090012-OP_r0
®
AIR N ARC 300 SERIES ALL-IN-ONE POWER SYSTEM
Installation must adhere to the safety
precautions listed in the Safety
Section of this manual for cooling
and noxious fume ventilation.
If mounting footprint is tighter than
the recommended minimum
requirements, consult the Vanair
Service Department for application
installation recommendations.
KEY
A 47 inches
B 45° angle
C 65° angle
D 36.75 inches (front panel extended)
39.75 inches (front panel etended /
I
E
with baffle option)
8 inch clear space (minimum)
I
F
G 48 inches (panel remote-mounted)
H 66 inches (panel mounted)
J 0.5 inches
All length measurements are minimum
clearance parameter approximations.
I
Unit must have a minimum of eight (8)
inch clearances on front and back sides
for ventilation.
1. Drill four (4) 9/16" mounting holes in the
service body floor on a 19.25" by 44.375"
square pattern at the desired mounting
location. Ensure that all proper machine
clearances will be maintained.
2. For units without a fuel tank, follow these
steps:
• Mount the electric fuel pump at the
desired location on the service body
keeping it as close to the truck fuel tank
WARNING
DESCRIPTION
NOTE
®