Engine Start-Up And Shutdown Procedure; Engine Start-Up - Vanair AIR N ARC RELIANT 300 Series Operations Manual & Parts List

SECTION 5: OPERATION
WARNING
Follow all applicable safety
recommendations as outlined in Section
1: Safety of this manual.
NOTE
If any of the compressor, generator or
welder switches are set to ON prior to
starting, the machine will start at full
speed.
IMPORTANT
All machine package maximum
operation angles of tilt are
fifteen degrees (15°) except for:
MAXIMUM machine angle of tilt
for operation for view shown
above is five degrees (5°).
WARNING
Machine hood and front access panel
must be closed before starting. Interlock
switches will not allow starting with
panels open. After starting, engine hood
may be opened, but opening belt access
panel will shut down the engine.
NOTE
Engine fault light will be on with the key
switch turned to the ON position before
starting the engine.
PAGE - 46
®
AIR N ARC 300 SERIES ALL-IN-ONE POWER SYSTEM
System Operation Group
Operating the Battery/Boost Charger
Connection - Disconnection Sequence
and Operation
Extreme Condition Operation
Cold Weather Operation
Engine Operation
Machine Operation
High Temperature Operation
Engine Operation
Machine Operation
High Dust Content Operation
Engine Operation
Machine Operation
High Altitute Operation
5.2 ENGINE START-UP AND
SHUTDOWN PROCEDURE
If start-up and shut-down procedures are
not followed, damage to the system and
its components may occur.
Consult Figure 5-1: Instrument Panel Functions for
operating procedures detailed in this section.
System Operation Group

Engine Start-up and Shutdown Procedure

Engine Start-up

Engine Shutdown
5.2.1 ENGINE START-UP
Consult Figure 5-3, and the following steps:
1. Check to make sure all switches [A] (Welder,
Generator, and Compressor) are in the OFF
position prior to starting.
2. Turn the engine control switch to the ON
position [B]; wait 3-5 seconds for the fuel
pump to prime the system. Depending upon
ambient temperature, wait until glow plug
light goes out (ten [10] seconds).
090012-OP_r0
Manual Location
Section
5.7 page 54
5.7.1 page 55
5.8 page 55
5.8.1 page 56
5.8.1.1 page 56
5.8.1.2 page 58
5.8.2 page 58
5.8.2.1 page 58
5.8.2.2 page 59
5.8.3 page 59
5.8.3.1 page 59
5.8.3.2 page 60
5.8.4 page 60
NOTE
Manual Location
Section
5.2 page 46
page 46
5.2.1
page 47
5.2.2
®