Vanair AIR N ARC RELIANT 300 Series Operations Manual & Parts List page 109

®
AIR N ARC 300 SERIES ALL-IN-ONE POWER SYSTEM
KEY
A ENGINE TEMPERATURE SWITCH
B ENGINE AIR FILTER
C ENGINE OIL FILL PORT
D FUEL FILTER
E ENGINE OIL DRAIN: TUBE & OUTLET
1. Locate the engine dipstick handle [ H ] and
remove.
2. Wipe off the excess oil on the dipstick blade,
and replace the dipstick back into the engine
tube in order to get a clear level reading.
3. Remove the stick again, and observe where
the oil level shows at the gauge-end of the
stick.
The level should be somewhere within the
range shown on the stick [between J
If the level shows low, replenish with the same
type of engine oil currently being used to
achieve a satisfactory level, by adding oil at
engine oil fill port [ C ].
If the engine is due for an oil change, or if operating
conditions require more frequent change intervals than
the normal routine maintenance schedule given in this
DESCRIPTION
Figure 6-16: Engine Components
090012-OP_r0
®
A
B
H
J
2
D
J
1
F
G
KEY
F ENGINE PRESSURE SWITCH
G ENGINE OIL FILTER
H ENGINE OIL DIPSTICK
J
ENGINE OIL LOW LEVEL MARK
1
J ENGINE OIL HIGH LEVEL MARK
2
and J ].
1 2
SECTION 6: MAINTENANCE
C
E
DESCRIPTION
PAGE - 91