Vanair AIR N ARC RELIANT 300 Series Operations Manual & Parts List page 58

SECTION 4: INSTALLATION
NOTE
For safety reasons the front access panel
contains a shut-off switch. The front
access panel will not allow the machine
to start if it is not in place, and will shut
down the machine if it is removed while
running. Consult Section 1.11, Machine
Canopy Access Safety Switch for further
information on the machine safety
switches.
D
E
F
A
B C
KEY
A BASE COVER
B TRUSS SCREW 1/4 (x6)
C NYLON FLAT WASHER 1/4 (x6)
D MOUNTING NUT 1/2 (x6)
E LOCK WASHER 1/2 (x4)
PAGE - 40
J
F
G
H
DESCRIPTION
Figure 4-4: Removing Package from Crate Mounting
090012-OP_r0
®
AIR N ARC 300 SERIES ALL-IN-ONE POWER SYSTEM
and circulation, and also package access for performing
maintenance (see Figure 4-1).
1. Refer to Figure 4-4. Remove the truss screws
[B], nylon flat washers [C] in order to remove
access panel covers ([A] and [K]) found on
both side ends of the unit.
2. To unbolt the unit from the skid, remove the
mounting nuts [D], lock washers [E], washers
[F] and mounting bolts [G] securing the
package unit [J] to the shipping crate.
3. Place the unit in a preliminary position on the
service body so that the front panel access
and hood opening (front) side is easily
accessible, and the control trunk line and all
other connections will reach the unit. Refer
to Figure 4-5 for lifting bail location.
J
H
KEY
F WASHER 1/2 (x8)
G MOUNTING BOLT 1/2 (x4)
H SHIPPING CRATE SKID PLATFORM
J AIR N ARC 300 PACKAGE UNIT
K BASE COVER (WITH CUTOUT)
D
E
F
K
F
G
C B
DESCRIPTION
®