Compressor Air Filter; Compressor Air Filter Check; Compressor Air Filter Check; System Component Or Part Group Task - Vanair AIR N ARC RELIANT 300 Series Operations Manual & Parts List

All-in-one power systems
Hide thumbs Also See for AIR N ARC RELIANT 300 Series:
Table of Contents

Advertisement

SECTION 6: MAINTENANCE
WARNING
Relieve pressure from the compressor
system before removing any
components.
D
KEY
DESCRIPTION
A
WING NUT (x 2)
B
AIR FILTER MOUNTING
COVER
C
AIR FILTER HOUSING ELE-
MENT
D
MOUNTING POSTS (x 2)
Figure 6-3: Compressor Air Filter
NOTE
If element is compromised by dirt, holes,
tears, or the gaskets are worn, or it is in
unsatisfactory condition, then it will need
to be replaced.
PAGE - 72
AIR N ARC
System Component or
Part Group Task
Re-tensioning the Air Compressor
Serpentine Drive Belt
Replacing the Air Compressor
Serpentine Drive Belt
Re-tensioning the Generator Ser-
A
pentine Drive Belt
B
Replacing the Generator Serpen-
tine Drive Belt
C
Re-tensioning the Engine
Hydraulic Pump Drive Belt
Replacing the Engine Hydraulic
Pump Drive Belt

6.6.1 COMPRESSOR AIR FILTER

The compressor oil is the key to a long useful life of the
air compressor system. Dirt and other foreign matter can
be introduced into the compressor system through the air
intake. A clean air filter will ensure that the compressor is
protected. Consult Section 6.3, Maintenance Schedule
Table for routine compressor air filter inspection
intervals.

6.6.1.1 COMPRESSOR AIR FILTER CHECK

Consult Figure 6-3 and the following procedure to check
the compressor air filter.
TOOLS/ITEMS NEEDED
Not Applicable
1. With the machine off and the ignition key
2. Remove the two (2) wing nuts [A] from the air
3. Remove air filter element [C] from the air filter
4. Inspect the air filter element for visible dirt,
090012-OP_r0
®
300 SERIES ALL-IN-ONE POWER SYSTEM
removed, open the hood panel.
filter cover [B] at the top of the compressor
unit.
mounting posts [D].
debris, or damage. NOTE: To perform a
more thorough inspection of the compressor
air filter element, refer to Section 6.6.1.2.
If element is in adequate shape to continue using:
®
Manual
Location
Section
6.6.15.1
page 93
6.6.15.2
page 95
6.6.15.3
page 97
6.6.15.4
page 98
6.6.15.5
page 100
6.6.15.6
page 101
REPLACEMENT
PART(S)
Not Applicable

Advertisement

Table of Contents
loading

Table of Contents