Vanair AIR N ARC RELIANT 300 Series Operations Manual & Parts List page 87

®
AIR N ARC 300 SERIES ALL-IN-ONE POWER SYSTEM
2. Remove the three (3) truss screws [B
three (3) washers [B
of the base cover [B
3. Set the base cover [B
4. Remove the four (4) serrated washer screws
[B ] fastening the right-side panel [J] to the
6
base frame.
STEP 3 - REMOVE THE CROSS BRACE SUPPORTS
AT BACK LEFT AND FRONT RIGHT
CORNERS
Refer to both insets [C] in Figure 6-2.
1. Remove the two (2) flat-head socket
capscrews [C
[C ] to the back panel [C
3
2. Remove the two (2) flat-head socket
capscrews [C
[C ] to the right side panel [C
6
STEP 3 - UNFASTEN THE HOOD SPRINGS FROM
THE SIDE PANEL STUD MOUNTS
Refer to both insets [D] in Figure 6-2.
1. Remove the mounting end caps [D
from the ends of the spring fasteners [D
D ] by carefully prying them loose with a
5
screwdriver blade.
2. Pull the ends of the spring fasteners [D
from the mounting studs [D
STEP 5 - LOOSEN THE BACK AND RIGHT-SIDE
PANEL CONNECTION BOLTS
Refer to both insets [E] in Figure 6-2. Note: The back
and right-side panels can remain attached to each other
for the removal process.
1. Loosen the three bolts [E
corner, but do not remove; also loosen the
three bolts [E
do not remove. Note: the bolts should be
loose enough to allow for the panel grooves
[E & E
2 4
bolts as shown in the inset diagrams.
] from the bottom edge
5
].
1
] and hardware aside.
1
] connecting the cross brace
2
].
1
] connecting the cross brace
5
] at the front.
4
& D
3 6
] at the back left
1
] at the front right corner, but
3
] to slide away from the mounted
090012-OP_r0
®
] and
4
& D ]
1 4
&
2
& D ]
2 5
].
SECTION 6: MAINTENANCE
PAGE - 69