Torque Instructions - Graco Husky 2200 Operation

Torque Instructions

Torque Instructions Torque Torque Instructions Instructions
If fluid cover or manifold fasteners have been
loosened, it is important to torque them using the
following procedure to improve sealing.
NOTE: Fluid cover and manifold fasteners have a NOTE: NOTE:
thread-locking adhesive patch applied to the threads.
If this patch is excessively worn, the fasteners may
loosen during operation. Replace screws with new
ones or apply medium-strength (blue) Loctite or
equivalent to the threads.
NOTE: Always completely torque fluid covers before NOTE: NOTE:
torquing manifolds.
1. Start all fluid cover screws a few turns. Then, turn
down each screw just until head contacts cover.
2. Turn each screw by 1/2 turn or less working in a
crisscross pattern to specified torque.
3. Repeat for manifolds.
Fluid Fluid Fluid cover cover cover and and manifold and
in-lb (21 to 25 Nm)
4. Retorque the air valve fasteners in a crisscross
pattern to the specified torque.
Air Air valve Air valve fasteners: valve fasteners: fasteners: 45 to 55 in-lb (5 to 6 Nm)
5. Retorque the pilot valves to the specified torque.
Do not not overtorque. overtorque.
Do Do not overtorque.
Pilot Pilot Pilot valves: valves: 20 to 25 in-lb (2 to 3 Nm) valves:
Fluid Cover Cover Screws Screws
Fluid Fluid Cover Screws
16
Tel: 866-777-6060
Fax: 866-777-6383
manifold fasteners: manifold fasteners: 190 to 220 fasteners:
Springer Pumps, LLC
Inlet and and Outlet Outlet Manifold Manifold Screws Screws
Inlet Inlet and Outlet Manifold Screws
Air Air Valve Air Valve Screws Valve Screws and Screws and Pilot and Pilot Valves Pilot
Website: www.springerpumps.com
Valves Valves
3A2578E
Int'l: +001 267 404 2910