Air Exhaust Ventilation; Fluid Supply Line - Graco Husky 2200 Operation

Air Air Exhaust Air Exhaust Exhaust Ventilation Ventilation Ventilation
If pumping toxic fluids, you must vent the exhaust
away from people, animals, food handling areas,
and all sources of ignition. Follow all applicable
codes.
The air exhaust port is 1 in. npt(f). Do not restrict
the air exhaust port. Excessive exhaust restriction
can cause erratic pump operation.
A Air supply line
B Bleed-type master air valve (may be
required for your pump installation)
C Air filter/regulator assembly
D Master air valve (for accessories)
J Air inlet port (not visible)
Fluid Supply Supply Line
Fluid Fluid Supply
1. Use grounded, flexible fluid hoses (E). See
Ground The System, page
3A2578E
Tel: 866-777-6060
Fax: 866-777-6383
NOTICE
NOTICE NOTICE
Line
Line
10.
Springer Pumps, LLC
To provide provide a a a remote remote exhaust: exhaust:
To To provide remote exhaust:
1. Remove the muffler (U) from the pump air
exhaust port (K).
2. Install a grounded air exhaust hose (S) and
connect the muffler to the other end of the hose.
The minimum size for the air exhaust hose is 1
in. (26 mm) ID. If a hose longer than 15 ft (4.57
m) is required, use a larger diameter hose. Avoid
sharp bends or kinks in the hose.
3. Place a container (T) at the end of the air exhaust
line to catch fluid in case a diaphragm ruptures.
If the diaphragm ruptures, the fluid being pumped
will exhaust with the air.
K Air exhaust port
S Grounded air exhaust hose
T Container for remote air exhaust
U Muffler
Website: www.springerpumps.com
Installation
11
Int'l: +001 267 404 2910