Setting The Outside Line; Setting The Area Code; Setting The Ringer On/Off By Line; Ringer Volume - Casio SI-460 User Manual

PROGRAMMING THE TELEPHONE

SETTING THE OUTSIDE LINE

If you must dial an outside line to access a dial tone, you can program the phone to automatically
dial the outside digit when calling a stored caller ID record.
1.
Press .
PROGRAM
2.
3.
4.
5.

SETTING THE AREA CODE

The area code is always included in caller ID records with telephone numbers. When your local
area code is programmed into the SI-460 and you press
area code is automatically removed.
If your local telephone company only requires 7-digits to make local calls, you need to program
your local area code. If your telephone company requires you to dial 10-digits for local calls, you
do NOT need to program the area code into the SI-460. If you are uncertain of your local calling
services, please contact your local telephone company.
To program your local area code,
1.
Press PROGRAM .
2.
3.
4.
6.
Press the soft key under "
the correct digit is displayed. (0 1 2 3 4 5
6 7 8 9 )
NOTE:
If an outside line is not needed, make sure there is a
"-" in the display.
7.
When the correct outside line digit
appears in the display, press
PROGRAM
exit.
to call a local caller ID record, the
DIAL
5.
6.
7.
Using the keypad, enter in your three digit
area code.
8.
9.
Press PROGRAM to exit.
16
PROGRAMMING THE TELEPHONE

SETTING THE RINGER ON/OFF BY LINE

Ringer settings for each outside line are individually controlled at each station. When the ringer
is turned "ON," the line will ring when calls are received. When the ringer is turned "OFF," that
line will not ring when a call is received. Whether the ringer is turned on or off, the LINE
INDICATORS will operate normally.
You can determine which lines ring at your station. All four lines are factory preset to ring on the
SI-460.
1.
" until
Press PROGRAM .
2.
3.
to
4.
5.
The " " and line number will
appear on the display.
The ringer volume can be set to HI, LOW or OFF. The ringer volume is factory pre-
set to HIGH. The ringer volume switch is located on the back of the SI-460. To
adjust the ringer volume, move the ringer volume switch to the desired position.
When the ringer volume is turned off, the unit will not ring when a call is received.

ADJUSTING FLASH DURATION

The flash setting is factory preset to 600 milliseconds, which is appropriate for most areas. The
flash can be set to 100 MS – 1000MS. If you are in an environment where a different flash
duration is needed:
1.
Press PROGRAM .
2.
6.
Press the soft key under "
toggle between turning the ringer "
" " for the selected line.
7.
Press the soft key under "
advance to the next line selection.
8.
Repeat steps 6 and 7 until all lines have
been programmed.
9.
Press PROGRAM

RINGER VOLUME

3.
Press the soft key under "
your selection flash duration appears.
4.
Press
PROGRAM
17
" to
" or
" to
to exit.
OFF LO HI
RING VOL.
" until
to exit.