Setting Always Ring; Setting A Private Line; Programming The Volume; Handset Volume - Casio SI-460 User Manual

PROGRAMMING THE TELEPHONE

SETTING ALWAYS RING

The Always Ring default setting is OFF. There are a few situations when a station will not ring.
1. A station will not ring when the auto attendant is on, unless the incoming call is transferred to
your station.
2. Your unit will ring when the auto attendant is off, but if you are already on the line, your
station will not ring when someone is calling in on another line.
If you would like your station to ring when off-hook on another line or when a call comes into the
auto attendant, set Always Ring to ON.
1.
Press PROGRAM .
2.
3.
4.

SETTING A PRIVATE LINE

You must share lines 1 and 2 with all other stations in the system. However you can create a
non-square configuration as described on page 7 using lines 3 and/or 4 so that your station has
different telephone numbers from the other stations' lines 3 and/or 4. More than one station can
share a private line. Once the private lines are connected to your unit, follow the programming
steps below:
1.
Press PROGRAM .
2.
3.
4.
5.
6.
NOTE:
Two or more stations can share the same private line(s), but under this condition your private line calls will always be
accessible (privacy is always released) to other stations that share the same line.
5.
6.
7.
8.
Press to exit.
PROGRAM
7.
8.
9.
10.
Use the keypad to select the line(s) that
you want to be private. Your private line
selection will appear in the display.
11.
12.
Press PROGRAM to exit.
18

PROGRAMMING THE VOLUME

You can individually set the volume level for the handset, speaker and headset and when using or
switching applications, the set volume level is automatically adjusted.

HANDSET VOLUME

While using the handset:
1.
Press to adjust the handset volume.
VOLUME
2.
As the volume is adjusted, 1-5 bars will appear on the LCD to visually display the handset
volume level. (1 bar representing low and 5 bars representing high volume.) The volume
setting will remain at this level until it is changed or a power failure occurs.
15
PM
SPEAKERPHONE / INTERCOM VOLUME
When using the speakerphone/intercom or when the phone is in standby mode,
1.
Press to set the speakerphone volume to the desired level.
VOLUME
2.
As the volume is adjusted, 1-8 sets of bars will appear to visually display the volume level on
the LCD. The volume setting will remain at this level until it is changed or a power failure
occurs. The lowest speakerphone volume is off.
When set to off, the display will show:

HEADSET VOLUME

While using the headset:
1.
Press to adjust the headset volume.
VOLUME
2.
As the volume is adjusted, 1-5 bars on the LCD will appear to visually display the headset
volume level. (1 bar representing low and 5 bars representing high volume.) The volume
setting will remain at this level until it is changed or a power failure occurs.
19