Operation; Switching On/Off; Lubrication; Cutting Process - Parkside PMK 550 A1 Translation Of The Original Instructions

Operation

Switching on/off

Switching the appliance on
♦ Move the ON/OFF switch
Switching the appliance off
♦ Move the ON/OFF switch

Lubrication

♦ Apply standard machine oil to the cutting line
to extend the service life of the grooved pin
and the die .
This is particularly important when cutting
aluminium .

Cutting process

♦ Hold the unit at a right angle (90°) to the work-
piece during the machining process .
♦ Move the appliance in the cutting direction with
gentle pressure .
Cut­outs
For internal cut-outs, a hole larger than 22,5 mm is
needed to insert the die holder
PMK 550 A1

Maintenance and cleaning

to the "I" position .
■
■
to the "0" position .
■
■
.
WARNING! RISK OF INJURY!
Switch the appliance off and remove
the power plug before starting any
work on the appliance.
The appliance must always be kept clean, dry
and free from oil or grease .
Use a soft, dry cloth to clean the housing .
The carbon brushes must be removed and
checked regularly . If they are worn down to the
limit of wear, they must be replaced . Always
keep the carbon brushes clean so that they can
slide freely in the holders . Both carbon brushes
should be replaced at the same time . Use only
identical carbon brushes .
Unscrew the brush holder caps
driver . Remove the worn carbon brushes, insert
the new ones, and then screw the brush holder
caps back on .
WARNING!
■ If the power cord needs to be replaced, this
must be done by the manufacturer or his re-
presentative to avoid safety hazards .
with a screw-
GB │ MT │ 39 ■