Before Use; Changing The Die Holder Position (See Fig . A); Permissible Material Thickness; Fitting And Removing The Grooved Pin And The Die Holder (See Figs . B + C) - Parkside PMK 550 A1 Translation Of The Original Instructions

Before use

WARNING! RISK OF INJURY!
► Switch the appliance off and remove the
power plug before starting any work on the
appliance .
Changing the die holder position
(see fig . A)
The die position can be adjusted by 360° .
Four working positions offset by 90° are specified .
The working positions can be set as follows:
♦ Loosen the hex screw
key .
♦ Turn the die holder
position so that the respective hole in the die
holder is facing towards the hex screw
♦ Retighten the hex screw
hex key .
♦ Rotate the die holder
it is fixed in the correct position .

Permissible material thickness

The maximum cutting capacity depends on the
material quality and strength .
The measuring grooves
holder can be used as a thickness gauge for the
permissible cutting thickness .
Never cut material thicknesses greater than those
specified in the technical data .
■ 38 │ GB │ MT
using the supplied hex
into the desired working
.
using the supplied
slightly to check whether
and on the die
Fitting and removing the grooved pin
and the die holder (see figs . B + C)
♦ To remove the grooved pin
holder , undo the hex screw
supplied hex key
♦ Pull the die holder
♦ Loosen the hex screw
key so you can remove the grooved pin
from the tool holder
♦ Insert the new supplied grooved pin
tool holder so that the hole in the grooved
pin is facing towards the hex screw
♦ Tighten the hex screw
grooved pin in place .
♦ Guide and insert the die holder
holder back into the appliance .
♦ Turn the die holder
position so that the respective hole in the die
holder is facing towards the hex screw
♦ Retighten the hex screw
hex key .
♦ Rotate the die holder
it is fixed in the correct position .
and the die
using the
.
from the appliance .
using the supplied hex
.
into the
.
firmly to secure the
via the tool
into the desired working
using the supplied
slightly to check whether
PMK 550 A1
.