ROLLER ALIGNMENT AND
STEP:17
UPRIGHT TUBE FINAL SECURE
As photo show
1) Set Two of the Roller Alignment Bar to each of the roller (Orange stopper
on the Alignment bar towards the Rail end) on the Alum. Rail.
2) Place both side Rollers to the center of the Alignment Bar.
3) If the Roller not be able to set right in the center to the Alum. Rail,
simply move the handlebar (#72I) slightly from side to side, roller
will set in the center of Alignment bar with ease
As photo shown : After set both roller in place, secure all screws (#18)
4)
originally finger lightly tightened in STEP 3, 4 and STEP 7. Finally with
the tool tighten all screws (# 18) firmly.
5) pull out the Alignment Bar from both Alum. Rail beside the rollers
Remark: In case user will like to adjust the Roller slightly, it can also follow
the Roller adjustment instruction on Pag 27
STEP:18
OPERATE THE ADJSTABLE STRIDE LENGTH‐ ADJUSTOR
As photo shown
1) First, pull the knob out and turn the adjustor base up or down.
2) to adjust the knob simply release it & pull up then more down
when the pointer aligned to a scale you desire
Note! there are five stride scale
3) Finally, tighten the adjustor base with a hex wrench
Note! if the scale shift occurs, you may manually correct the pointer position.
STEP:19
As photo shown
1) Plug the power cord with power adaptor (#92) into an appropriate outlet
IMPORTANT: The elliptical exerciser is not compatible with
GFCI‐equipped outlets.
2) The other end of the access hole in the rear of the base frame
Note! before plug in, please check the voltage specifications on the
label.
JOYSPORT
www.joysport.nl
POWER ADAPTOR
NO
PARTS LIST
QUANTITY
*
4
NO
PARTS LIST QUANTITY
*
1
NO
PARTS LIST QUANTITY
#92
1
17