Advertisement
Available languages
Available languages
STEP:5
As photo shown
1) Set the step foot coves (#104,#105) Top/Bottom with the pedal support
tube (#75)
2) locking up the covers with the screw (#30), then fix the covers with 2
self‐tapping screws(#122).
STEP:6
As photo shown
1) Frist, distinguish between the left/right pedal support tube (note: check pedal
support tube with left/right label)
2) move pulley to the upper position, insert rear part of both pedal support tube
(#75) to the axle on pulley.
3) add washers (#17), nut (#12), locking up the nut (#12) with axle
4) then tighten up the rear pedal support tube coveers (#108/#109) with screws
(#122)
The distinction between pedal support tube covers left/right
NOTE!
STEP:7
As photo shown
1) insert both of connecting tubes (#86) with front part of step tubes to the
swivel tubes (#69)
2) Connecting both (#86) tube with (#69 & #70) with screws (#18).
NOTE: Use finger lightly tighten the (#18) screws at this STEP, DO NOT
TIGHTEN TOTALLY
STEP:8
As photo shown
Pre‐asssebled ball bearing on both end of long connecting bars (#100), check
the sign of "UP " one side with big ring & one with samll ring, use the big ring
side check the "outside " direction as figure shown connecting it with the
small axle on the swinging axle plate (#101), add a washer (#39), screw (#18)
locking up both screws firmly cover the plastic covers (#46) to the big ring
JOYSPORT
www.joysport.nl
STEP FOOT COVEER ASSY.
PEDAL SUPPORT TUBE ASSY ( 1 )
PEDAL SUPPORT TUBE ASSY ( 2 )
LONG CONNECTIING BAR ASSY
NO
PARTS LIST QUANTITY
#122
4
#30
2
NO
PARTS LIST QUANTITY
#12
2
#17
2
#122
8
NO
PARTS LIST QUANTITY
#18
4
NO
PARTS LIST
QUANTITY
#18
2
#39
2
#46
2
11
Advertisement
