Advertisement
Available languages
Available languages
STEP:1
FRONT SUPPORT ( Front Stabilizer) ASSY.
As photo shown
1) in order to facilitate assembly, use one of the larger styroform set under the
Frame ( as photo shown)
2) Attach the front support with transportation wheels to the frame with two
bolts (#19) washers (#65) nuts (#20)
3) locking sleeves with tool and cover the nut with two caps (#21)
STEP:2
As photo shown
1) In order to facilitate assembly, use one of the larger styroform set under the
Frame ( as photo shown)
2) Attach the rear support to the frame with two bolts (#19) washers (#65)
nuts (#20)
3) locking sleeves with tool and cover the nut with two caps (#21)
STEP:3
As photo shown
1) place the pre‐assembled upright tube (#68) flat on the floor ( as photo shown)
1‐1) First, connect the cables between upright tube and the adjustor (#116)
1‐2)pull another section cables of upright tube facilitate enter to the upright tube
2) the adjustor with semi‐circular piece with the tube and align the bolt.
Note! the adjustor can not hold against the upper and lower
3) hand tightern the adjustor with four bolts ( #18) to the upright tube
NOTE! DO NOT TOTALLY TIGHTEN ALL FOUR BOLTS (#18).
KEEP THE ADJUSTOR IS MOVEABLE FROM SIDE TO SIDE AT THIS POINT.
STEP:4
As photo shown
1) place upright tube on top of a chair ( or by a second person to assist
holding) close to the main frame be facilitated to connect the cables.
2) check the direction of upright tube before connect the Top/Bottom
pre‐assembled cables as photo shown.
3) Use finger lightly tighten the six scews (#18) for the upright tube
NOTE: DO NOT tighten these screws (#18) totally at this STEP.
JOYSPORT
www.joysport.nl
REAR SUPPORT ( Rear Stabilizer) ASSY.
STRIDE LENGTH ADJUSTOR ASSY.
UPRIGHT TUBE ASSY. TO THE FRAME
NO
PARTS LIST
QUANTITY
#19
2
#65
2
#20
2
#21
2
NO
PARTS LIST QUANTITY
#19
2
#65
2
#20
2
#21
2
NO
PARTS LIST
QUANTITY
#18
4
NO
PARTS LIST
QUANTITY
#18
6
9
Advertisement
