norix TNT0500-00XT Assembly Instructions

www.norix.com ● TEL 800 234-4900
Assembly Notes:
Norix is not responsible for any damage due to improper installation. If your shipment does not match the parts list, please contact Norix Customer Service at 800-234-4900.
Norix reserves the right to modify design specifications at any time without an obligation to owners of previously sold products.
___________________________________________________________________________________________________________________________________________________________________________________________________
ITEM QTY. PART NUMBER
A 1 030-114-XX
B 3 021-010
C 3 025-003
D 2 026-008
E 1 025-024
Mounting the Safety Rail to a Panel Bed.
• If unit has drawers, the drawers will need
to
be removed to allow fasteners to be
assembled underneath. To remove drawers,
remove the two drawer stop screws inside the
drawers.
NOTE: (1) 026-008 NUT / WASHER IS NOT
REQUIRED FOR THIS INSTALLATION.
1. Mark (3) hole locations on bed Top Panel
to
be drilled. Use Top Panel attachment screws
to locate the Safety Rail (Detail A). The screw
heads will fit into the small clearance holes in
the bottom flange on the Safety Rail. The
screws should not need to be removed. Mark
the (3) hole locations to be drilled. Use a
center punch as needed, and drill the holes to
7/16" dia. One of the holes may go through
the top flange of the support panel
underneath
the bed (if so equipped). Clean burrs from the
holes.
2. Referring to Detail A, assemble the Safety
Rail to the bed using (3) 3/8" Screws (B), and
(3) 3/8" Lock Washers (C). On the underneath
side, (2) 3/8" Nut/Washers (D) will be used in
the locations where there is no support panel
(Detail B). In the support panel location (Detail
C), a Hex Nut (E) will be used. Insert the Hex
Nut in the opening and slide into place. When
the screw is tightened from the top, it will draw
the Hex Nut tight.
3. Tighten hardware securely.
Rev. E - 12/7/15
091-728
Titan Safety Rail
Assembly Instructions
Model Number
TNT0500-00XT
Parts List
DESCRIPTION
Safety Rail, Titan
Screw 3/8-16 x 1 Btn Hd Torx Pin Blk Ox
Washer 3/8 Lock, Blk Ox
Nut/Washer Assy 3/8-16 Weld Nut, w/Driloc, Zinc
Nut 3/8-16 Zinc
A
Slide hex nut through
opening in support
C
DETAIL A
D
panel
E
Drawer Channel
Support Panel
Tools Needed
Low RPM Variable Speed Drill
7/16" Drill Bit
T-45 Torx Driver
5/8" Wrench
A
B
Mark and drill holes
3 places.
Locate clearance
holes over Top Panel
screw heads. Do not
remove screws.
DETAIL B
Page 1 of 2