Table of Contents
Advertisement
Assembly and installation
6.4 Assembling and connecting the UV lamp
24
4.
Carefully push the UV lamp protection tube until it reaches its
stop position in the reactor.
5.
Push a new O-ring onto the end of the UV lamp protection
tube.
6.
CAUTION!
–
Check the UV lamp protection tube for
damage before fitting.
–
–
Ensure that the UV lamp protection tube
is sitting correctly.
WARNING!
Electrical installation
Cause: Danger from electrical voltage.
Possible consequence: Fatal or very serious inju‐
ries.
Measure: Prior to assembly and connection of the
UV lamps, switch off the master switch or pull the
mains plug out of the socket.
WARNING!
UV-C radiation
Cause: Danger due to
Consequence: UV radiation is harmful to the eyes
and skin.
Measure: Only start up the UV lamps when they
are properly installed.
NOTICE!
Premature UV lamp failure
Never touch the UV lamp glass with bare hands.
Fingerprints burn into the glass and can result in
premature failure. Use a cloth moistened with
alcohol to clean off fingerprints from the lamp
before installation.
The UV system should be installed in accordance
with all pertinent regulations prior to commissioning
With free-standing UV systems, attach the con‐
necting plug with lamp cover to the UV lamp before
the UV lamp is inserted into the lamp protection
tube.
1.
Insert the lamp cover O-ring into the groove provided.
2.
Insert the UV lamp into the UV lamp protection tube and
allow it to project out approx. 100 mm.
Never re-fit a damaged UV lamp pro‐
tection tube.
UV radiation.
UV-C
Advertisement
Table of Contents
