Operation And Control (Compact Control); Operating Modes; Operating Levels - ProMinent 80 W Assembly And Operating Instructions Manual

Operation and control (Compact Control)

5 Operation and control (Compact Control)

5.1 Operating modes

5.2 Operating levels

14
The control of the UV system is used to monitor and control the
connected UV lamps, valves etc.
The control monitors the lamps in the UV disinfection unit during
operation, switches connected valves, and issues a message:
when the required safety threshold is transgressed.
n
when a thermal switch is required if a defined operating tem‐
n
perature is exceeded.
when a flow detector is required if a defined flow is trans‐
n
gressed.
During operation, the control displays the radiation intensity in
W/m , the operating hours and the lamp activations alternately (60
2
seconds / 10 seconds / 10 seconds).
The control has 3 operating modes:
Off
n
Manual. Remote switching is not possible; the function is used
n
for service purposes
Automatic
n
The control can be switched to
nally.
Bridge in terminal 7/8
If the control is not controlled externally, then ter‐
minal 7/8 must be bridged.
Remote activation is provided by the contact of terminal 7/8.
The UV system is operated exclusively at operating level L5. L5 is
the sole operating level authorised for operation in compliance with
DVGW [German Technical Association for Gas and Water] W294
and ÖNORM [Austrian Standard] M5873-1.
There are 4 different modes:
Operating mode
n
– Default mode during operation of UV system
Programming mode
n
System parameter mode
n
Test mode
n
'Automatic' operating mode exter‐