Honeywell Performance Series User Manual page 83

Figure 6-9 SD Card Error Warning Configuration Interface
Figure 6-10 Capacity Warning Configuration Interface
1. Click Enable so that an alarm is triggered when the selected Micro SD card error occurs.
2. Click Email so that an email is sent to a specified receiver if the selected Micro SD card
error occurs.
Note Emails cannot be sent if the network is offline or if there is an IP conflict. The email
settings must be configured for this feature to be used (see
page 53).
3. Enter a Capacity Limit for the Capacity Warning Micro SD card error as the threshold for
how full the SD card will get before the Capacity Warning is sent.
Configuring for Network Abnormalities
Use these options to configure for Network Abnormalities such as network Disconnection and
IP Conflict.
Configuring Events and Alarms | 83
SMTP (Email) on
800-22756 - B - 04/2017