Configuring Alarms Input Options - Honeywell Performance Series User Manual

80 | Performance Series 5 MP Fisheye IP Camera User Guide
Parameter
Enable
Working Period
Heat Map Reports
You can search through the heat map data on the Report interface (see
a report based on the search results.
1.
2.
3.

Configuring Alarms Input Options

The alarms feature uses the alarm input built-in to the camera to connect to an external device,
such as a sensor, to activate an alarm with the camera and generate a response. To use the
alarms feature you must connect an external alarm device to the alarm input on the camera
before configuring the Alarms options interface (see
www.honeywell.com/security
Table 6-4 Heat Mapping Configurations
Function
Check to enable the Heat Mapping function.
The heat mapping function is activated during the specified period. See
Configuring the Working Period on page
Click Setup. You can configure up to six periods per day. Draw a circle
in the table to enable the corresponding time period. Select a date. If
you do not select a date, the current setup will be applied to today only.
You can select All to apply the working period to the whole week.
Click Save to save the changes. The system goes back to the Heat
Map interface. Click Save to exit.
Enter a Begin Time and End Time to search for the heat map data. The search time range
should be one week or less.
Click Search to generate the report data from the time period entered.
If the search results are acceptable, click Export to generate the heat map data as a
report. If needed, perform a new search to find the required heat map data.
Figure 6-6 Heat Map Reports Interface
76.
Figure 6-6) and generate
Figure 6-7 and Table 6-5).