Electrical Connections; Test The System - Simer Ace-In-The-Hole A5000 Owner's Manual

Electrical

ELECTRICAL CONNECTIONS

Hazardous voltage. Can cause serious or
fatal electrical shock. Review the safety instructions
before operating the charger. Do not modify the cord or
plug.
1. Attach the wires as indicated in Table I and as illus-
trated in Figures 4 and 6. Neatly coil any excess
transformer cord and tape it near the transformer.
115V AC
Grounded
Outlet
Transformer
Transformer
Socket and Plug
Back-Up
Pump
Figure 4 - Wiring Connections.
Control Panel
Figure 5 - Control Panel.
For parts or assistance, call Simer Customer Service at
Control Panel
Float Switch
Socket and Plug
Back-Up Pump
Connection
and Plug
Green
Red
Yellow
NOTICE: With the transformer plugged in and the bat-
tery connected, either the green (Battery Ready) light
or the yellow (Charge Required) light should come on.
See Figure 5. If not - Check your battery connections
and the battery. For further trouble shooting refer to
the Troubleshooting Section on Page 7.
2. With the system installed correctly the performance
will be as indicated in Table III, Page 6.

TEST THE SYSTEM

1. With the wires connected, lift the float to the "ON"
position. The pump will run and the Pump Cycled
light will turn on.
2. Lower the float switch to just below the "OFF" posi-
tion and the pump will stop running. The Pump
Cycled light will remain on.
3. Push the Reset Pad on the control box, and the Pump
Cycled light will go out.
TABLE I – WIRING CONNECTIONS
Connect the ... To ...
1. Control Box the Battery and activate Reset
Switch
2. Back-up Pump the Pump Connection in the
Power Cord Control Panel
3. Float Switch the Float Switch Socket in the
Connector Control Panel
4. Transformer from the Transformer Socket in the
Wall Outlet Control Panel
Control
Panel
Figure 6
1-800-468-7867 / 1-800-546-7867
5
Connect the wires from
the back of the control
panel to the battery posts.
Battery