Advertisement
1. Place the fan on a safe, flat surface where it cannot fall or be pulled by the cord.
2. Plug the fan into a grounded outlet.
3. To set the horizontal direction of airflow, hold the fan housing neck in one hand,
make sure the oscillating knob is in the up position and then turn the cage left
or right.
4. To control the vertical direction of airflow, grip the
handle on top of the fan tightly and loosen the wing
nut on the side of the fan housing neck. Adjust to the
desired angle and tighten the wing nut.
5. To make the fan oscillate, push down on the oscillating
knob located on the top of the fan housing, near the
handle. To stop the fan from oscillating, pull up on the
oscillating knob.
6a. To sleect a speed on the table model move the switch
lever located on the base of the fan from OFF to the
desired speed setting of 1 (low), 2 (medium) or 3
(high).
6b. To select a speed on the floor model, move the switch
knob located on the back of the motor housing from OFF
to the desired speed setting of 1 (low), 2 (medium) or 3
(high).
Table & Floor Fan Only
7. OPTIONAL: To store the excess cord, unplug the fan from
the wall socket and gently lay the fan on its side,
making sure that the cage and motor are properly
supported. To remove the base bottom unscrew all of
the screws. Remove the cord restraint screw. Gently
pull the cord through the bottom rubber bushing
(assuring it remains in place) and through the cord
restraint until you have the desired length. If the
rubber bushing in the base has come loose, reinstall it
into the base of the fan. Re-align the cord restraint to
the proper position to reattach it to the base with the
screw. Feed the excess cord into the neck of the base.
For the table fan, keep it away from the speed switch
assembly. Replace the base bottom, aligning the screw
holes and reinstall the screws, assuring that no wires or
cord are pinched.
OPERATING INSTRUCTIONS
RUBBER
BUSHING
SPEED SWITCH
ASSEMBLY
FOR TABLE & DESK FAN:
SCREWS
CORD
RESTRAINT
CORD
RESTRAINT SCREW
FOR FLOOR FAN:
Advertisement
