Canopy Hatch Installation; Bulb Installation; Installing The Glass - Casablanca Stealth Owner's Manual

Casablanca stealth ceiling fans: owners manual

Hide thumbs Also See for Stealth:

Instructions manual (18 pages)

Manual (16 pages)

Owner's manual and installation manual (2 pages)

Table Of Contents

Table of Contents

Step 6. Tuck the wires into the canopy with the wire nuts

pointed upwards, so that the white and black wires are on

opposite sides of the canopy and all wires are clear of the

canopy opening.

Step 7. Install canopy hatch with the last canopy screw and

lock washer. To do this, tilt the fan body away from the hatch

opening.

Tip: Place the lock washer on the canopy screw,

and the screw through the hatch before tilting the

fan to install the hatch onto the canopy.

Step 8. Straighten the fan, then check to ensure that there

is no movement between the canopy and ceiling or Hang-Tru

ball and downrod.

Step 9. Screw the Q100/MC Halogen bulb into the socket. Do

not touch the glass bulb with your fingers–it is extremely

important that the glass be clean. If it is touched, or dirty,

clean carefully with a tissue. A dirty glass bulb will cause the

bulb to fail almost immediately.

IMPORTANT! When installing the halogen bulb, care-

fully cut off the end of the plastic sleeve the bulb

comes in and hold the bulb by the plastic sleeve to

screw it into the socket.

Step 10. Position the indentations in the

outer rim of the glass so that they line

up with the tabs on the inside surface of

the fan light fixture rim.

Step 11. Carefully lift the glass shade up

inside the light fixture as far as it will go.

Step 12. Rotate the glass shade in a

clockwise direction until it falls into the

notch for each tab.

Step 13. Turn power back ON at the cir-

cuit breaker or fusebox.

This completes the installation of the fan.

PROCEED TO YOUR FAN'S CONTROL FEATURE SECTION FOR INSTALLATION/OPERATING INSTRUCTIONS: