Crossbar Mounting Bracket Installation; Canopy Installation - Casablanca Stealth Owner's Manual

CROSSBAR MOUNTING BRACKET INSTALLATION

Proceed with installation as follows:
Step 1. Route the wires from the ceiling outlet box through
the crossbar mounting bracket center hole. Attach the bracket,
with ground wire and ridges down, to the ceiling fixture out-
let box with the mounting hardware included with the outlet
box.
Tighten the screws firmly by hand only, be careful not to
bend the bracket by over tightening.
CAUTION: To reduce the risk of
personal injury, use only the
mounting hardware provided with
the approved outlet box to install
the crossbar mounting bracket.
CANOPY
CANOPY
HATCH
Step 2. Attach the canopy to the cross bar with three of the
8-32 x 2 1 long canopy screws and hand tighten until snug
/
2
against the ceiling. On sloped ceilings, align the canopy open-
ing toward the top or peak of the room. Your Casablanca fan
may be installed on a vaulted or cathedral ceiling in the
same manner as described for a flat ceiling. The Hang-Tru
mounting system makes it possible to hang your fan on ceil-
ings sloped up to a 32 angle.
Note: On sloped ceilings, align the
canopy opening towards the top or
room peak.
CANOPY/BLADE HARDWARE/GLASS
CANOPY SCREW (4)
CANOPY
LOCK WASHER (4)

CANOPY INSTALLATION

®
S
CEILING FAN
APPROVED
OUTLET BOX
CEILING
WIRING
CROSSBAR
MOUNTING
BRACKET
FLAT
WASHER
OUTLET BOX
MOUNTING
HARDWARE
TRUSS HEAD
BLADE SCREW
(4 PER BLADE)
FIBER WASHER
(4 PER BLADE)
CROSSBAR MOUNTING
BRACKET INSTALLED
CANOPY
CANOPY LOCK
WASHERS
CANOPY
SCREWS
®
TEALTH
RIDGE
SIDE
DOWN
GREEN
GROUND
WIRE
GLASS
HALOGEN BULB
4