Casablanca Bel Air Halo Owner's Manual page 4

B
EL
CROSSBAR MOUNT-
ING BRACKET
CROSSBAR MOUNTING BRACKET INSTALLATION
Note: After removing the old fixture, check the outlet box
to insure that it is supported by a joist or beam across its
upper surface. If not, a 2" x 4" stud must be installed.
Step 1. Remove the knockout plug in the center of the out-
let box or drill a ʺ hole for the lag screw to pass through.
1
/
2
Then drill a ʺ guide hole into the joist or beam to a depth
1
/
4
of 3ʺ.
Step 2. Route the outlet box wires through the keyhole slot of
the crossbar mounting bracket as shown. Attach the crossbar
mounting bracket to outlet box with screws provided, assuring
that the outlet box wires are not pinched by the washer.
CAUTION: To reduce the risk of personal injury,
use only the mounting hardware provided with
the approved outlet box to install the crossbar
mounting bracket.
WARNING!
SUPPORT DIRECTLY TO
BUILDING STRUCTURE ONLY.
4
A H
IR ALO
CEILING HARDWARE
WIRE NUT (4)
SUPPORT INSTALLATION PARTS
LAG SCREW
/ " #7 X 5" (1)
3
8
™
ADDITIONAL HARDWARE
1" x 8-32 ROUNDED
HEAD SCREW (2)
JOIST
CEILING FAN
APPROVED
WIRING BOX
CROSSBAR
MOUNTING
BRACKET
FLAT
WASHER
APPROVED
OUTLET BOX
HARDWARE
2 " x 8-32 ROUNDED
1
/
4
HEAD SCREW (2)
FLAT WASHER (2)
LARGE
FLAT WASHER
/ " (1)
3
8
CEILING
WIRING
RIDGE
SIDE
DOWN
GREEN
GROUND
WIRE