Casablanca Bel Air Halo Owner's Manual page 10

Inteli•Touch
INTELI•TOUCH OPERATION POWER
The POWE button is normally left in the on position. Always turn the
POWER
power off during cleaning or servicing the fan and during thunderstorms. It
is also used to exit or enter additional programs.
POWER must be left on to retain a previously set fan speed or
light level.
INTELI•TOUCH OPERATION SPEED CONTROL
There are six individual speed settings for the fan; each speed is indicated
by an audible tone of increasing pitch.
To select the desired fan speed:
1. With fan off, press and hold the button labeled
will start rotating at the slowest speed, and will increase in steps.
2. Release the button when the desired speed is reached.
The fan speed is now in memory and will automatically come on at the same
speed each time the
FAN
turn the fan on by pressing
turn fan off, then on by pressing and holding the
desired speed is reached. When the fan is on, you may increase the speed by
pressing and holding the
then release it.
INTELI•TOUCH • REVERSING AIRFLOW
The direction of airflow can be changed from downward to
upward or from upward to downward.
To reverse the airflow:
1. Make sure the
FAN
FAN
2. Press the button.
REVERSE
To turn the lights off and on, press and release the
than one second.
The sequence is, when the power is on:
First touch of the light button—both lights come on
Second touch of the light button—down light only
Third touch of the light button—up light only
To vary the light brightness at each touch level:
Make sure where you are in the sequence to the right.
To dim both lights at the same time:
1. Make sure you have the uplight on.
2. Turn the light off, then press and hold the
second, both lights will come on at their lowest setting and gradually
become brighter.
3. Release the button when the desired brightness is reached.
LIGHT
To dim just the up light:
1. Make sure you have just the downlight on.
2. Turn the light off, then press and hold the
second, the up light will come on at the lowest setting and gradually
become brighter.
3. Release the button when the desired brightness is reached.
LIGHT
To dim just the down light:
1. Make sure you have both lights on.
2. Turn the light off, then press and hold the
second, the down light will come on at the lowest setting and gradually
become brighter.
3. Release the button when the desired brightness is reached.
LIGHT
10
™
FAN
button is used. To maintain this level of speed,
less than one second. To lower speed,
FAN
FAN
button until the desired speed is reached,
FAN
is on.
INTELI•TOUCH OPERATION ♦ LIGHT
LIGHT
button. After one
LIGHT
button. After one
LIGHT
button. After one
LIGHT
FAN CONTROL
ON - OFF
. The fan blades
A momentary
press of the FAN
button
TO CHANGE SPEED
Press and hold
button until the
FAN button longer
than one second
Note: A four-toned signal indi-
cates the command was accepted
by the fan. A few seconds later
the fan will slow to a stop and
then reverse direction.
button for less
LIGHT CONTROL
CYCLES THROUGH SE-
QUENCE:
1. Both lights come on
2. Down light only
3. Up light only