Func./Hold Key; Before First Use; Inserting/Replacing The Batteries - Westfalia Wetekom 82 67 24 Instruction Manual

The FUNC./HOLD Key (2)
 Press the FUNC./HOLD key (2) to freeze any current value on
the display (3). The word "D.H" is shown. Press the
FUNC./HOLD key again to return to displaying the currently
measured values.
 Data hold mode is available only in voltage, current and
resistance measuring modes.
 Use the FUNC./HOLD key to switch the meter between the
diode and the continuity test function when the rotary function
switch is set to

Before first Use

Unpack the digital clamp meter and check the unit for any
damage in transit. Dispose of packaging materials or store it out
of reach of children. Plastic bags etc. may become a deadly toy
for children.

Inserting/Replacing the Batteries

Attention! Before changing the batteries! Disconnect the unit from
all circuitry and remove the measuring cables.
1. Use the rotary function switch (6) to turn the unit OFF.
The unit is powered by two CR2032 batteries.
2. Loosen the screw of the battery compartment lid (9) on the
rear side of the device and remove the lid.
3. Insert two new button cells into the
battery compartment. Pay attention to
the proper polarity of the batteries. The
plus poles face out of the compartment.
4. Replace the battery compartment lid
and secure it with the screw. Do not operate the meter with a
removed battery compartment lid.
Operation
.
25
+ +