Table of Contents
Advertisement
Installation surface
A concrete floor is the most suitable
installation surface. It is far less prone
to vibration during the spin cycle than
wooden floorboards or a carpeted
surface.
The machine must be level and
securely positioned.
To avoid vibrations during spinning,
the machine should not be installed
on soft floor coverings.
If installing on a wooden joist floor:
Install the machine on a plywood
base (at least 70 x 60 x 3 cm). The
base should span several joists and
be bolted to the joists and not only to
the floorboards.
Useful tip: If possible, install the
machine in a corner of the room. This is
usually the most stable part of the floor.
Removing the transit bars
Removing the left transit bar
Push the flap outwards and turn the
transit bar 90° using the enclosed
spanner.
Then pull the transit bar out.
Installation
51
Advertisement
Table of Contents
