Package Contents - Stanley STDC18LHBK Instruction Manual

ENGLISH
(Original instructions)
• Charge only using the charger provided with the tool.
• When disposing of batteries, follow the instructions given
in the section "Protecting the environment".
Do not attempt to charge damaged batteries.
Chargers
• Use your charger only to charge the battery in the tool with
which it was supplied. Other batteries could burst, causing
personal injury and damage.
• Never attempt to charge non-rechargeable batteries.
• Have defective cords replaced immediately.
• Do not expose the charger to water.
• Do not open the charger.
• Do not probe the charger.
The charger is intended for indoor use only.
Read the instruction manual before use.
LABELS ON TOOL
The following pictograms are shown on the tool along with the
date code:
WARNING! To reduce the risk of injury, the user
must read the instruction manual.
Always wear safety goggles
Always wear safety hearing protection
Position of date code
The Date Code, which also includes the year of manufacture,
is printed into the housing.
Example:
2 0 1 5
Year of manufacturing

PACKAGE CONTENTS

The package contains:
1 Hammer drill
1 Charger
2 Batteries (C2/S2/D2) or 1 Battery (C1/S1/D1)
1 Instruction manual
• Check for damage to the tool, parts or accessories which
may have occurred during transport.
• Take the time to thoroughly read and understand this
manual prior to operation.
FEATURES (Fig A)
This tool includes some or all of the following features.
1. Variable speed switch
2. Forward/reverse slider
3. Mode selector / torque adjustment collar
4. Chuck
5. Speed selector
12
X X
6. Bit holder
7. Battery
8. LED work light
9. State of charge indicator
10. Belt clip
FIG.B
11. Charger
12. Charge indicator
ASSEMBLY
WARNING! Before assembly, remove the battery from the tool.
Fitting and removing the battery (Fig C)
• To fit the battery (7), line it up with the receptacle on the
tool. Slide the battery into the receptacle and push until the
battery snaps into place.
• To remove the battery, push the release button (13) while
at the same time pulling the battery out of the receptacle.
Fitting and removing a drill bit or screwdriver bit
This tool is fitted with a keyless chuck to allow for an easy
exchange of bits.
• Lock the tool by setting the forward/reverse slider (2) to the
centre position.
• Open the chuck by turning it (4) with one hand while
holding the tool with the other.
• Insert the bit shaft into the chuck.
• Firmly tighten the chuck by turning it (4) with one hand
while holding the tool with the other.
• Insert the bit shaft into the chuck.
• Firmly tighten the chuck by turning it (4) with one hand
while holding the tool with the other.
This tool is supplied with a double-ended screwdriver bit in the
bit holder (6).
• To remove the screwdriver bit from the bit holder, lift the bit
from the recess.
• To store the screwdriver bit, firmly push it into the holder.
J N
USE
WARNING! Let the tool work at its own pace. Do not overload.
WARNING! Before drilling into walls, floors or ceilings, check
for the location of wiring and pipes.
CHARGING THE BATTERY (Fig B)
The battery needs to be charged before first use and whenever
it fails to produce sufficient power on jobs that were easily
done before. The battery may become warm while charging;
this is normal and does not indicate a problem.
WARNING! Do not charge the battery at ambient temperatures
below 10 °C or above 40 °C. Recommended charging
temperature: approx. 24 °C.
NOTE: The charger will not charge a battery if the cell
temperature is below approximately 0 °C or above 40 °C.
The battery should be left in the charger and the charger
will begin to charge automatically when the cell tempera-
ture warms up or cools down.