Package Contents - Stanley STHR202 Manual

LABELS ON TOOL
The label on your tool may include the following symbols:
WARNING! To reduce the risk of injury, the user
must read the instruction manual before use.
Wear safety glasses or goggles.
Wear ear protection.
V Volts
A Amperes
Hz Hertz
W Watts
min minutes
Alternating
Current
Position of Date Code
The Date Code 12, which also includes the year of
manufacture, is printed into the housing.
Example:
2017 XX JN
Year of manufacturing

PACKAGE CONTENTS

The package contains:
1 SDS-Plus rotary hammer
1 Side handle
1 Depth stop
1 Instruction Manual
1 Kit box
• Check for damage to the tool, parts or accessories which
may have occurred during transport.
• Take the time to thoroughly read and understand this
manual prior to operation.
FEATURES (Fig E)
This tool includes some or all of the following features.
1. Variable speed switch
2. Lock-on button
3. Mode selector
4. Tool clamp
5. Side handle
6. Depth stop
7. Forward/Reverse lever
Direct Current
n No-Load Speed
0
Class II Construction
Earthing Terminal
Safety Alert Symbol
Revolutions or
/min. Reciprocation per
minute
(Original instructions)
ASSEMBLY
WARNING! Before assembly, make sure that the
tool is switched off and unplugged.
Attaching the side handle (Fig E)
WARNING! When drilling holes in concrete or
bricks, please use the side handle for your safety.
• Turn the grip counterclockwise until you can slide the side
handle onto the front of the tool.
• Rotate the side handle into the desired position.
• Tighten the side handle by turning the grip clockwise.
WARNING! When using the tool, remember to
install the side handles properly.
Fitting an accessory (fig.A)
• Clean and grease the shank (15) of the accessory.
• Insert the accessory bar into the tool clamp(4).
• Push the accessory down and turn it slightly until it fits into
the slots.
• Pull on the accessory to check if it is properly locked. The
hammering and drilling function requires the accessory to
be able to move axially several centimetres when locked
in the tool clamp.
• To remove the accessory, pull back the sleeve (8) and pull
out the accessory from the tool clamp.
USE
WARNING! Please operate tool with normal load.
Do not overload.
WARNING! Before drilling into walls, floors or
ceilings, check for the location of wiring and pipes.
Selecting the operating mode (Fig B)
The tool can be used in two operating modes. Based on
actual work requirements, the drilling mode selector (3) can be
rotated to the required position.
Hole drilling / Screw driver (Fig B,F,G,H)
• For drilling in steel, wood and plastics or tighten and loose
screw, set the operating mode selector (3) to the
( ) position. At the same time, it is necessary to use a
suitable drill chuck (13) (optional accessory) to clamp the
attachment rod.
• Insert the drill chuck (13) into the tool chuck (4) according
to the instructions for installing attachments. Turn the drill
chuck to loosen the clamps at the front-end of the
drillclamp, and insert the accessory bar (14) into the
clamps and turn the chuck in the opposite direction. You
may also use the drill chuck key to tighten the clamp.
• For drilling in steel, wood and plastics, set the forward/
reverse lever(7) to the forward position(Fig G). When use
for screw driver function, tighten screws set the forward/
reverse lever (7) to the forward position(Fig G) and loose
screws set the forward/reverse lever (7) to the reverse
position(Fig H).
ENGLISH
5