Automatic Dialing - Canon MultiPASS C635 User Manual

The MultiPASS automatically redials if the receiving fax does not answer,
if the line is busy, or if a transmission error occurs. You can specify the
number of times it redials using the Retries option in the Send Fax panel
of the MultiPASS Fax Setup Utility (see "Setting Up Send Fax Options"
in Chapter 3, Using the MultiPASS Fax Setup Utility). If all redial
attempts fail, the MultiPASS beeps intermittently for a few seconds. If
this happens, check the fax number and try sending the fax again.
If the light is flashing, correct the error described in the LCD
ALARM
display, and then press . You may need to open the operator panel
STOP
to remove the document from the ADF (see page 8-3).

Automatic Dialing

You can send a document using one-touch speed dialing, coded speed
dialing, or group dialing. You must register the one-touch speed dialing
numbers, the coded speed-dialing numbers, and the group dialing
numbers with the MultiPASS Fax Setup Utility before you can send
documents using these automatic dialing methods. See "Setting Up
Speed Dial Assignments" in Chapter 3, Using the MultiPASS Fax Setup
Utility.
1
❍ Place the document face down in the ADF.
Load the
document.
DOCUMENT READY
4-4 Sending Faxes With the MultiPASS C635 Chapter 4