Opening The Diagonal Belt Guide; Removal Of The K-Fix + After Semi-Universal Use; Removing And Applying The Cover; Removing The Back Rest Cover - KIDDY Guardianfix 3 Directions For Use Manual

EN
In order to secure your child with the 3[point vehicle seat belt, proceed as fol-
lows:
Pull the vehicle seat belt out and place the lap belt under the two armrests (D)
of the seat (I) (Fig. 25). Ensure that the lap belt is in the lowest possible position.
Now close the belt latch. Check whether the belt latch has engaged correctly
(Fig. 25).
Tighten the lap belt and place the diagonal belt under the arm rest (D) on the
belt latch side (Fig. 26).
Guide the diagonal belt between the red diagonal belt guide (B) and the head
support (G) (Fig. 27, No. 1). Now pull the belt inward towards your child's neck
(Fig. 27, No. 2).
Please ensure that the belt latch opposite the diagonal belt
!
guide (B) is used (Fig. 28).
Ensure that the belt is positioned in the diagonal belt guide (B) and is not
clamped in the front on the hook (Fig. 28).
The belts may not be twisted and must run closely along you child's body. En-
sure the correct position of the vehicle belt latch.
Then tighten the belt system (Fig. 29).
Check the belt run regularly during longer trips.

8 Opening the diagonal belt guide

In order to open the diagonal belt guide (B), press down (Fig. 30, No. 1) and pull
the belt out the side (Fig. 30, No. 2).
32

9 Removal of the k-fix + after semi-universal use

Actuate the unlocking handle (R) (Fig. 31, No. 1) while simultaneously pulling the
seat (I) away from the vehicle back rest (Fig. 31, No. 2).
+
Open the left and right k-fix connectors (E) by sliding the unlocking mecha-
nisms (S) forward (over the 'green' locking display (T)) (Fig. 32).
The kiddy guardianfix 3 is uncoupled from the vehicle structure when both con-
nectors (E) are open.
+
Finally, the k-fix connectors (E) must be retracted into the seat.
To do so, rotate the connectors (E) towards the seat (Fig. 33). For this purpose,
actuate the unlocking handle (R) (Fig. 34, No. 1) and push the connectors (E)
completely into the seat (I) (Fig. 34, No. 2). The connectors must be correctly
retracted into their respective recesses in the seat.
Now release the unlocking handle (R).

10 Removing and applying the cover

Never use your kiddy child restraint system without the origi-
!
nal cover. The cover is part of the safety concept.

10.1 Removing the back rest cover

The back rest cover is a single piece and covers both the shoulder supports (H)
and the head support (G).
Slide the heat support (G) to a middle position.
Now disengage the cover from the height adjustment handle (P) and pull it
forward over the head support.
Now disengage the cover from the belt guide (B).
EN
33