Top Tether Anchorages - Subaru Legacy Outback 2008 Owner's Manual

Station wagon
If the child restraint system requires a top
tether, latch the hook onto the top tether
anchorage and tighten the top tether.
Refer to the "Top tether anchorages"
section for additional instructions.
For further information, refer to the in-
struction manual supplied by the child
restraint system manufacturer.
CAUTION
When you install a child restraint
system, follow the manufacturer's
instructions supplied with it. After
installing the child restraint system,
check to ensure that it is held
securely in position. If it is not held
tight and secure, the danger of your
child suffering personal injury in the
event of an accident may be in-
creased.
NOTE
Before installing a child restraint sys-
tem, ask the manufacturer of the sys-
tem to confirm that it is one approved
for your vehicle.
& Top tether anchorages
Your vehicle is provided with two or three
top tether anchorages so that a child
restraint system having a top tether can
be installed in the rear seat. When
installing a child restraint system using
top tether, proceed as follows, while
observing the instructions by the child
restraint system manufacturer.
Since a top tether can provide additional
stability of connection between a child
restraint system and the vehicle, we
recommend that you use a top tether
whenever one is required or available.
Seat, seatbelt and SRS airbags
! Anchorage location
! Sedan
Two or three anchorages are installed on
the rear shelf behind the rear seat.
– CONTINUED –
1-39