Subaru Legacy Outback 2008 Owner's Manual page 143

3-16
Instruments and controls
NOTE
The outside temperature indication
may differ from the actual outside
temperature. The indication "OUT
TEMP 38C (378F)" should be treated
only as a guide. Be sure to check the
condition of the road surface before
driving.
! Journey time
1) Outside temperature
2) Journey time
The journey time shows the time that has
elapsed since the ignition switch was
turned to the "START" position.
After 2 hours have passed for the journey
time, the display indication flashes "E/T
2:00" at the center of the display for 3
seconds and gives a notice to the driver to
take a rest. After 3 seconds, it returns to its
original indication of the outside tempera-
ture and journey time.
If you continue to drive your vehicle
without stopping the engine, the display
flashes the journey time for 3 seconds at
the center of the display after each
additional hour has elapsed.
If the display shows an indication other
than the journey time, the display switches
to the journey time for 3 seconds for each
additional hour that has elapsed after the
first 2 hours. After 3 seconds, it returns to
its original indication. However, if the
journey time indication overlaps with an-
other indication, the journey time indica-
tion is shortened.
NOTE
The journey time is reset when the
ignition switch is turned to the "LOCK
(off)" position. It is also reset if the
ignition switch is turned to the "LOCK
(off)" or "Acc" position prior to restart-
ing of the engine.