Subaru Legacy Outback 2008 Owner's Manual page 309

7-48
Starting and operating
Type B
The indicator light turns on when the
ignition switch is turned to the "ON"
position; it turns off approximately 2
seconds later. This indicator light flashes
during activation of the skid suppression
function and is illuminated steadily during
activation of the traction control function.
The following two situations could indicate
a malfunction of the Vehicle Dynamics
Control system; if either should occur, we
recommend that you have an authorized
SUBARU dealer carry out an inspection of
that system at the first available opportu-
nity.
. The indicator light does not turn on
when the ignition switch is turned to the
"ON" position.
. The indicator light does not turn off
approximately 2 seconds after the ignition
switch has been turned to the "ON"
position.
! Vehicle Dynamics Control warning
light/Vehicle Dynamics Control OFF
indicator light
Type A
Type B
This single light has the function of
indicating malfunctions in the Vehicle
Dynamics Control system and the function
of indicating that the Vehicle Dynamics
Control system is not operating. It comes
on in the event of a malfunction in the
system and is illuminated whenever the
system is not operating.
! Vehicle Dynamics Control warning
light
The warning light comes on when the
ignition switch is turned to the "ON"
position and goes off several seconds
after engine startup. This lighting pattern
indicates that the Vehicle Dynamics Con-
trol system is operating normally.
The following situations could indicate a