Delta DelREMO-V2.0 User Manual page 29

XXIII. Follow below path to enter sensor configuration setting
Configure>Sensor
There are 4 attributes being used to manipulate sensor values as per customer requirement and these
are as follows:
Name: This is used name sensor depends upon their type and the nature of reading it provided.
Type: This field enables/disabled the effect of offset and multiplier into the original value supplied by
sensor.
"None" should be set under type if sensor customization does not required however if want so then
turn type into "custom" mode to activate offset and multiplier to get appropriate value at the output.
Offset/Multiplier: These are the two elements being used to calibrate sensor reading, can be varied
according to sensor deployed.
•
29