System Configuration - Delta DelREMO-V2.0 User Manual

Check input supply to adapter is
1
switched ON.
Check for output 24VDC voltage at the
2
output of adapter.
Check for LED operation of DelREMO-
3
V2.0

4.1.3 System Configuration

After DelREMO-V2.0 is powered ON, connect the DelREMO to Laptop/PC via Ethernet port provided at the
bottom of unit using RJ45 cable. Following settings are to be done on Laptop/PC to access the DelREMO:
-
I. Click on Start TAB, and then go to Control Panel TAB as Shown below.
II. After Clicking on Control Panel, window will appear as shown, click on Network and sharing
Center.
III. After Clicking on Network and sharing Center, window will appear as shown, click on Change
adapter settings.
IV. After clicking on change adapter settings, the window will appear as shown; right click on the icon
"Local area connection" as shown below.
V. Now click on properties as highlighted.
VI. After clicking Properties window will appear as shown, select Internet Protocol Version 4
(TCP/IPv4), then clicks on properties (highlighted in yellow).
After clicking on properties window will appear as below and select "Use the following IP
VII.
address". Now do setting as provided in below snapshot, after doing setting click on OK Tab.
IP Address : 192.168.100.1
Subnet Mask : 255.255.255.0
•
17